Filter
Top Products
1-3
Product Overview
Installation Notes
Mounting
The MPX G2 is equipped with a 3-pin IEC power connector and detachable
cord. The unit will operate with power sources from 100 to 240 volts AC, 50-
60Hz. Power switching to actual line voltage is automatic.
Power Requirements
The MPX G2 uses one EIA-standard rack space, and can be mounted on any
level surface or in a standard 19 inch (483 mm) rack. If the unit is mounted in a
rack or road case, support the rear of the chassis to prevent possible damage
from mechanical shock and vibration.
The maximum ambient operating temperature is 104°F (40°C). Provide ade-
quate ventilation if the unit is mounted in a closed rack with heat-producing
equipment such as power amplifiers.
Press System twice.
Press Yes in response
to the display prompt..
You’re here because you want to play with the MPX G2 RIGHT NOW. Plenty of
time to read the manual later right?
OK. First things first. If the MPX G2 isn’t fresh out of the box, let’s make sure that
all of the internal parameters are set to their original factory settings. (This won’t
affect any user programs.)
1. Press System twice.
2. Use the knob to select Initialize.
3. Press > to display All.
4. Use the knob to select System Only.
5. Press Store.
6. The display will show: Are you sure?/Yes or No.
7. Press Yes.
What happens next depends on how you want to connect and use the MPX G2.
Setups for of the three basic configurations is covered in the following pages.
• Stand Alone: connected directly to headphones, mixer or power amp
• Amp Input Only: connected to a guitar amp that does not have an effects loop
• Amp Input & FX Loop: connected to a guitar amp that has a mono or stereo
effects loop
Each application has its own set of programs — so be sure to listen to the
programs that match the application.
Quick Start
Reset the MPX G2 to its
factory settings
(User programs are not affected.)
Use the knob to
select Initialize.
Press > to select All.
Use the knob to select
System Only.
Press Store.