9. Service Mode
By default the Baudrate is set to 9600.
How to Change the Baudrate?
1. Push the cursor key ↑ or ↓ to highlight Change Baudrate and press ENTER to select. (menu 9-15)
The B audrate menu will be displayed, the actual Baudrate will be highlighted. (menu 9-16)
2. Push the cursor key ↑ or ↓ to highlight the desired Baudrate and press ENTER to confirm.
3. Press EXIT to return to the Projector Set-Up menu.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
COMMON ADDRESS: 0
BARCO LOGO
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 9-15
BAUDRATE
Select new
baudrate:
9600 4800
2400 1200
600 300
150
Select with arrow
keys:
<ENTER> to accept
<EXIT> to return
Menu 9-16
9.3.8 Power Up Mode Operating/Stand-By
What can be done?
When pressing the power switch, the projector can start up in ’operating mode’ or in ’stand-by mode’.
Operating The projector start up and displays image.
Stand-By The projector start up in stand-by and waits until the stand-by button or a digit key is pressed
How to toggle Power Up Mode Operating/Stand By?
1. Push the cursor key ↑ or ↓ to highlight Power Up Mode .. (menu 9-17)
2. Press ENTER to select to toggle between Operating and Standby.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
COMMON ADDRESS: 0
BARCO LOGO
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 9-17
9.3.9 Common Address
What can be done?
Every projector listens to a common address. This c omm on address can be set to ’0’ or ’1’. W he n a RCU is programmed with that
common address, ev ery pr ojector with that same comm on address will follow up the commands given by that RCU.
Why 2 different Common Addresses?
The reason to have the choice to select between common addresses is, to avoid co n trolling of other IR controlled units, e.g. a TV
set with standard common address 0.
88
R5976584 BA RCO CINE7 26022003