Filter
Top Products
9. Service Mode
9.3.1 Starting Up Projector Set-Up
Start up
1. Push the cursor key ↑ or ↓ to highlight Projector Set-Up and press ENTER to select. (m enu 9-3)
The Projector S et-Up menu will be disp layed. (menu 9-4)
SERVICE MODE
PROJECTOR SET UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 9 -3
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
COMMON ADDRESS: 0
BARCO LOGO
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 9 -4
9.3.2 Identification
What can be seen?
The Identification screen gives information concerning:
• Projector address, to change the address of your projector, contact a qualified service technician.
• Software version.
• Configuration, pos sible installations: Front-ceiling, Front-table, Rear-ceiling, Rear-table.
• Baud rate PC: transfer speed for communication with an IBM PC (or compatible) or M AC. The baud rate of the projector must
be the same as the baud rate of the connected computer. When there is a difference, contact a qualified service technician to
make the appropriate changes.
• Text On/Off: indicates in operational mod e if the bar scale and number indicator will be displayed and if warnings and failures
will be displayed (ON: displayed, OFF: not displayed). The status can be changed by pressing the TEXT key once on the RCU.
• Serial No. : indicates the fabrication number o f the p rojector. This number can be useful when calling for technical assistance.
How to start up Identification?
1. Push the cursor key ↑ or ↓ to highlight Identification and press ENTER to select. (menu 9-5)
The Identification screen will be displayed. (menu 9-6)
2. Press EXIT to return to the Projector Set-Up menu.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating
COMMON ADDRESS: 0
BARCO LOGO
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 9 -5
BARCO
CINE 7
Proj. address: 001
Soft. Version: 2.11
Config.: Ceiling
Front
Baudrate PC: 9600
Text: ON
Serial No.: 1035895
Menu 9 -6
9.3.3 Total Run Time
What can be seen?
The total sy stem run time since the first s tart up can be displayed plus the run time of the separate C RT’s since the last reset.
All projectors leave the factory after a burn-in period of approximately 100 hours.
R5976584 BARCO CINE7 26022003 85