Filter
Top Products
4. Getting Started
Do not display a stationary image with full brightness and contrast for longer than 20 min., otherwise you risk
dam age to the CR T’s.
How to switch off the projector?
1. Use the sam e power switch to switch o ff the p rojector.
4.5 Using the RCU
Pointing to the reflective screen
1. Point the front of the RCU to the screen surface. (image 4- 4)
Image 4-4
Hardwired Remote Input
1. Plug one end of the rem ote cable in the connector on the bottom of the RCU. (image 4-5)
2. Plug the other end in the connector on the rear panel labelled ’Remote’.
Image 4-5
Directly to the IR sensors
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line). The
remote control u nit will not function properly if s trong light strikes the sensor window or if there are obstacles b etween the remote
control unit and the projector’s IR sensor.
26
R5976584 BA RCO CINE7 26022003