Filter
Top Products
Page 82 - Part 1 IP Connectivity How Do I?
Task Description
Step 5
Add the following routing entries.
Unit1
• IP Address = 192.168.50.0
• IP mask = 255.255.255.0
• Destination = wan_link
Unit2
• IP Address = 192.168.200.0
• IP mask = 255.255.255.0
• Destination = wan_link
A Routing entry must be configured to allow the IP packets to
be routed to the correct destination (see IP Routing on page
62).
Step 6
Submit configuration and Test
Configuration
Use the Monitor application and select PPP and check LCP
Tx/Rx and Security Tx/Rx. This will show whether the call is
cleared as result of bad password.
If PPP echo Request/Reply are observed then this is shows
the link is established.
If Echo Request/Reply is observer yet it is not possible to
PING the remote check the IP routing configuration.
Note: The IPNC setup for 'Remote Terminal Users' is identical to that given for VoIP trunking in the example
above except that the numbers used will be the 'Reserved Number' (default 18) for the rquired number of
terminals. Refer to the INDeX Programming Manual for details.
Page 82 - How Do I? INDeX IPNC Cassette Administration Manual
Part 1 IP Connectivity 38DHB0002UKDD – Issue 7 (22/11/02)