Filter
Top Products
Appendix D: Use Of The Serial Port Erasing/Re-Installing Operational Software - Page 131
Erasing/Re-Installing Operational Software
It may be necessary to carry out this procedure because the software is
corrupted.
Note: A replacement copy of software is installed from the Manager PC via the
LAN, so ensure that the PC is connected and the Manager is running.
Proceed as Steps 1 and 2 above, type AT-X[Enter] and wait whilst the memory is
erased and the new software loaded, as shown below.
Replacing the Operational Software in Flash Memory
Loader 1.1 DualFlash (2MB-2xF800 Flash-120nS DRAM-70nS EDO)
AT
OK
AT-X
Multi-Sector Erase
OK
Received BOOTP Response :C0.A8.2A.01 IPNC.bin
TFTP Load Start
TFTP Load complete
Note: The command View/TFTP Log used immediately after the AT-X command
shows the BootP request sent to the Manager and the progress of the
download:
: Received BOOTP request for 00e007000123 192.168.42.1 IPNC.bin
: Sending BOOTP response for 00e007000123 192.168.42.1 IPNC.bin
: Sending IPNC.bin length 654321 bytes to 192.168.42.1
: Sent 10% of IPNC.bin
: Sent 20% of IPNC.bin
: Sent 30% of IPNC.bin
: Sent 40% of IPNC.bin
: Sent 50% of IPNC.bin
: Sent 60% of IPNC.bin
: Sent 70% of IPNC.bin
: Sent 80% of IPNC.bin
: Sent 90% of IPNC.bin
: Sent 100% of IPNC.bin
: Sent IPNC.bin length 654321 bytes
INDeX IPNC Cassette Administration Manual Appendix D: Use Of The Serial Port - Page 131
38DHB0002UKDD – Issue 7 (22/11/02) Erasing/Re-Installing Operational Software