80 CHAPTER 4: PORT COMMANDS
Examples — The following command disables PoE on ports 4 and 5,
which are connected to an MAP access point:
WX1200# set port poe 4,5 disable
If you are enabling power on these ports, they must be connected only to approved
PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y
The following command enables PoE on ports 4 and 5:
WX1200# set port poe 4,5 enable
If you are enabling power on these ports, they must be connected only to approved
PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y
See Also
■ “set port type ap” on page 82
■ “set port type wired-auth” on page 86
set port preference Configures a gigabit Ethernet port on a WX4400 to use the RJ-45
(copper) interface, when available, as the active link instead of the fiber
interface.
Syntax —
set port preference port-list rj45
■ port-list — List of physical ports. MSS sets the preference on all the
specified ports.
■ rj45 — Prefers the copper interface.
Defaults — When both the copper and fiber interfaces of a gigabit
Ethernet port are connected, the GBIC (fiber) interface is the active link.
The RJ-45 (copper) link is unused.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400.
If you set the preference to RJ-45 (copper) on a port that already has an
active fiber link, MSS immediately changes the link to the copper
interface.
