470 CHAPTER 18: FILE MANAGEMENT COMMANDS
Table 91 describes the fields in the display boot output.
See Also
■ “clear boot config” on page 463
■ “display version” on page 472
■ “reset system” on page 476
■ “set boot configuration-file” on page 479
display config Displays the configuration running on the WX switch.
Syntax — display config [area area] [all]
■ area area — Configuration area. You can specify one of the
following:
■ aaa
■ acls
■ ap
■ arp
■ eapol
■ httpd
■ ip
■ ip-config
■ log
■ mobility-domain
Table 91 Output for display boot
Field Description
Configured boot
image
Boot partition and image filename MSS will use to boot next
time the software is rebooted.
Configured boot
configuration
Configuration filename MSS will use to boot next time the
software is rebooted.
Booted version Software version the switch is running.
Booted image Boot partition and image filename MSS used the last time
the software was rebooted. MSS is running this software
image.
Booted configuration Configuration filename MSS used to load the configuration
the last time the software was rebooted.
