282 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Examples — The following command sets the power interval for radios
in radio profile rp2 to 240 seconds:
WX4400# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
See Also
■ “set {ap | dap} radio auto-tune max-power” on page 266
■ “set {ap | dap} radio auto-tune max- retransmissions” on page 267
■ “set radio-profile auto-tune power-backoff- timer” on page 279
■ “set radio-profile auto-tune power-config” on page 280
set radio-profile
beacon-interval
Changes the rate at which each MAP radio in a radio profile advertises its
service set identifier (SSID).
Syntax —
set radio-profile name beacon-interval interval
■ name — Radio profile name.
■ interval — Number of milliseconds (ms) between beacons. You can
specify from 25 ms to 8191 ms.
Defaults — The beacon interval for MAP radios is 100 ms by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command
.
Examples — The following command changes the beacon interval for
radio profile rp1 to 200 ms:
WX4400# set radio-profile rp1 beacon-interval 200
success: change accepted.
See Also
■ “display radio-profile” on page 254
■ “set radio-profile mode” on page 287
