clear radius client system-ip 405
See Also
■ “set radius” on page 407
■ “set radius server” on page 409
■ “display aaa” on page 180
clear radius client
system-ip
Removes the WX switch’s system IP address from use as the permanent
source address in RADIUS client requests from the switch to its RADIUS
server(s).
Syntax —
clear radius client system-ip
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The clear radius client system-ip command causes the WX
switch to use the IP address of the interface through which it sends a
RADIUS client request as the source IP address. The WX switch selects a
source interface address based on information in its routing table as the
source address for RADIUS packets leaving the switch.
Examples — To clear the system IP address as the permanent source
address for RADIUS client requests, type the following command:
WX4400# clear radius client system-ip
success: change accepted.
See Also
■ “display aaa” on page 180
■ “set radius client system-ip” on page 408
clear radius server Removes the named RADIUS server from the WX configuration.
Syntax —
clear radius server server-name
■ server-name — Name of a RADIUS server configured to perform
remote AAA services for the WX switch.
