148 CHAPTER 6: IP SERVICES COMMANDS
See Also
■ “clear ntp server” on page 113
■ “clear ntp update-interval” on page 113
■ “display ntp” on page 125
■ “set ntp server” on page 148
■ “set ntp update-interval” on page 149
set ntp server Configures a wireless LAN switch to use an NTP server.
Syntax — set ntp server ip-addr
■ ip-addr — IP address of the NTP server, in dotted decimal notation.
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You can configure up to three NTP servers. MSS queries all the
servers and selects the best response based on the method described in
RFC 1305, Network Time Protocol (Version 3) Specification,
Implementation and Analysis.
To use NTP, you also must enable the NTP client with the set ntp
command.
Examples — The following command configures a WX switch to use
NTP server 192.168.1.5:
WX4400# set ntp server 192.168.1.5
See Also
■ “clear ntp server” on page 113
■ “clear ntp update-interval” on page 113
■ “display ntp” on page 125
■ “set ntp” on page 147
■ “set ntp update-interval” on page 149
