260 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
See Also
■ “set service-profile auth-dot1x” on page 295
■ “set service-profile auth-fallthru” on page 296
■ “set service-profile auth-psk” on page 298
■ “set service-profile beacon” on page 299
■ “set service-profile cipher-ccmp” on page 299
■ “set service-profile cipher-tkip” on page 300
■ “set service-profile cipher-wep104” on page 301
■ “set service-profile cipher-wep40” on page 302
■ “set service-profile psk-phrase” on page 303
■ “set service-profile psk-raw” on page 304
■ “set service-profile rsn-ie” on page 305
■ “set service-profile shared-key-auth” on page 306
■ “set service-profile ssid-name” on page 307
■ “set service-profile ssid-type” on page 307
■ “set service-profile tkip-mc-time” on page 308
■ “set service-profile web-aaa-form” on page 308
■ “set service-profile wep active-multicast- index” on page 310
■ “set service-profile wep active-unicast- index” on page 311
■ “set service-profile wep key-index” on page 311
■ “set service-profile wpa-ie” on page 312
reset {ap | dap} Restarts an MAP access point.
Syntax — reset {ap port-list | dap dap-num}
■ ap port-list — List of ports connected to the MAP access points to
restart.
■ dap dap-num — Number of a Distributed MAP to reset.
Defaults — None.
Access — Enabled.
