set dot1x authcontrol 425
set dot1x
authcontrol
Provides a global override mechanism for 802.1X authentication
configuration on wired authentication ports.
Syntax —
set dot1x authcontrol {enable | disable}
■ enable — Allows all wired authentication ports running 802.1X to
use the authentication specified per port by the set dot1X
port-control command.
■ disable — Forces all wired authentication ports running 802.1X to
unconditionally accept all 802.1X authentication attempts with an
EAP Success message (ForceAuth).
Defaults — By default, authentication control for individual wired
authentication is enabled.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to wired authentication ports.
Examples — To enable per-port 802.1X authentication on wired
authentication ports, type the following command:
WX4400# set dot1x authcontrol enable
success: dot1x authcontrol enabled.
See Also
■ “display dot1x” on page 421
■ “set dot1x port-control” on page 428
Logoffs While
Authenticating
Number of times that the WX switch state wildcard
transitions from AUTHENTICATING to ABORTING, as a result
of an EAPoL-logoff message being received from the
Supplicant (client).
Bad Packets Received Number of EAPoL packets received that have an invalid
version or type.
Table 77 display dot1x stats Output (continued)
Field Description
