272 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To enable or disable one or more radios to which a profile is
assigned, use the set ap radio radio-profile command. To enable or
disable all radios that use a specific radio profile, use the set
radio-profile command.
Examples — The following command enables radio 1 on the MAP access
points connected to ports 1 through 5:
WX1200# set ap 1-5 radio 1 mode enable
success: change accepted.
The following command enables radio 2 on ports 1 through 3:
WX1200# set ap 1-3 radio 2 mode enable
success: change accepted.
See Also
■ “clear {ap | dap} radio” on page 232
■ “display {ap | dap} config” on page 234
■ “set {ap | dap} radio radio-profile” on page 272
■ “set radio-profile mode” on page 287
set {ap | dap} radio
radio-profile
Assigns a radio profile to an MAP radio and enables or disables the radio.
Syntax — set {ap port-list | dap dap-num} radio {1 | 2}
radio-profile name mode {enable | disable}
■ ap port-list — List of ports.
■ dap dap-num — Number of a Distributed MAP.
■ radio 1 — Radio 1 of the MAP.
■ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
■ radio-profile name — Radio profile name of up to 16 alphanumeric
characters, with no spaces.
■ mode enable — Enables radios on the specified ports with the
parameter settings in the specified radio profile.
