15
802.1X MANAGEMENT
COMMANDS
Use 802. IEEE X management commands to modify the default settings
for IEEE 802.1X sessions on an WX switch. For best results, change the
settings only if you are aware of a problem with the WX switch’s 802.1X
performance.
CAUTION: 802.1X parameter settings are global for all SSIDs configured
on the switch.
Commands by
Usage
This chapter presents 802.1X commands alphabetically. Use Table 76 to
locate commands in this chapter based on their use. For information
about configuring 802.1X commands for user authentication, see “AAA
Commands” on page 163.
Table 76 802.1X Commands by Usage
Type Command
Wired Authentication Port
Control
“set dot1x port-control” on page 428
“clear dot1x port-control” on page 417
“set dot1x authcontrol” on page 425
Keys “set dot1x key-tx” on page 426
“set dot1x tx-period” on page 432
“clear dot1x tx-period” on page 420
“set dot1x wep-rekey” on page 433
“set dot1x wep-rekey-period” on page 433
Bonded Authentication “clear dot1x bonded-period” on page 416
“set dot1x bonded-period” on page 426
Reauthentication “set dot1x reauth” on page 429
“set dot1x reauth-max” on page 430
