Filter
Top Products
CONFIGURING THE AUDIO INPUT SIGNAL SETTING
70
You can play back most audio sources without a problem with the factory audio input signal setting (AUTO). However,
depending on your needs, you can configure the audio input mode to specify an input signal type that can be used on the
CinemaStation. Also, you can check the type of the audio signal currently input into the CinemaStation (page 71) with
the CinemaStation display.
1 Press and hold the Input selection button for
the current input source until the input mode
you want to select appears in the
CinemaStation display.
While holding down the button, the input mode
changes as follows:
↓
AUTO
↓
DTS
↓
ANLG
AUTO: Plays a source according digital signals priority
over analog signals.
DTS: Plays only DTS signals.
ANLG: Plays only analog signals.
y
• You can also switch input modes for the currently selected input
by pressing and holding INPUT on the CinemaStation.
• If a Dolby Digital or DTS signal is input while the input mode is
set to “AUTO”, the CinemaStation automatically select the
most suitable decoder for the signal.
• With “Input Mode” in the Set Menu (page 79), you can set the
mode that the CinemaStation automatically selects when it is
turned on.
• You cannot set “ANLG” for the DVD/CD input selection
button.
• You cannot switch input mode for the button if no external AV
equipment is connected to the corresponding input jacks.
• To play back a DTS signal, be sure to set the input mode to
“AUTO” or “DTS”. Setting the mode to “ANLG” may produce
noises or no sounds.
• The following conditions may happen if a DTS signal is input
while the input mode is set to “AUTO”.
– If the CinemaStation detects a DTS signal, it automatically
switches to DTS mode (t lights up). Once DTS audio
playback finishes, the t blinks for a while. While it is
blinking, you cannot play back audio source other than DTS
signals. If you want to play normal PCM audio soon after
DTS playback, set the input mode to “AUTO” again.
– If the DTS signal is interrupted when you perform Search or
Skip, the t may blink. If this condition continues for over
30 seconds, the Input mode automatically changes from DTS
to normal digital (PCM) and the t goes out.
Configuring the Audio Input Signal Setting
TV
CH
CINEMA
CH
POWER
AUDIO
SELECT
NIGHT
SW
TV CH
TV INPUT
SLEEP
PRESET PRESET
A B C D E
CENTER
SURR
SHIFT
STEREOMATRIX 6.1
A-B
REPEAT
ANGLE
SUBTITLE
ON SCREEN MENU
TEST
RETURN
STATUS
TV VOL
VOLUME
MUTE
AMP
DVD/CD
VCR
VIDEO
TUNER
MOVIE MUSIC SPORTS GAME
ENTER
YPAO
ON/OFF
STANDBY/ON
START
PTY SEEK
MODE
SURROUND
SET MENU
START
FREQ/RDS
Input selection
buttons
Notes