Filter
Top Products
9.3.6 Feedback
Press F12 (disable) before changing feed
-
back parameters.
Feedback Type:
Select the feedback type used.
Leave all other fields unchanged.
If Software Enable is active, a warning appears.
The configuration change cannot be performed.
Click OK on the warnings, press F12 (SW dis
-
able) and start the Feedback procedure again.
If everything was ok, the same procedure (pa
-
rameter upload) that has been described for the
motor selection starts.
If you click "Yes", the parameters are saved in
the EEPROM and the amplifier makes a
coldstart (reset). This takes some seconds.
80 SERVOSTAR
®
601...620 Product Manual
Setup
07/2007 Danaher Motion