Filter
Top Products
Original GreenStar Display—RTK
OUO6050,0000C3E –19–17OCT07–1/1
Quick Survey Mode
SETUP
JOHN DEERE
RTK Operating Mode
VEHICLE
RTK
A
B
C
D
E
F
G
RTK Radio
Channel (1-14)
RTK Network ID
(1-4000)
Configure
Repeater Radio
1
1
PC9578 –UN–06NOV06
SETUP - RTK
A—RTK Operating Mode
B—RTK Radio Channel
C—RTK Network ID
D——
E—Configure Repeater Radio
F——
G——
NOTE: Display is not required after base station receiver
has been configured to operate in Quick Survey
Base Mode and RTK Frequency, Radio
Channel/Network ID have been set.
Check that base station, vehicle, and repeater
have same Frequency, Network ID and Time Slot.
Connect display to base station.
Screen: SETUP - RTK
Press: SETUP >> STARFIRE RECEIVER >> DIFF
CORRECTION SETUP >> RTK SETUP
NOTE: Quick Survey Base Mode allows base station to
broadcast corrections after receiver calculates
GPS position.
If power is removed from base station (but not
moved) power can be restored and same base
station position will be used for corrections. If
previously used Track 0 is recalled in Parallel
Tracking/Auto Trac no Shift Track will be needed.
If power is removed and base station is moved, a
new position will be calculated when power is
restored. If previously used Track 0 is recalled in
Parallel Tracking/Auto Trac, use Shift Track. (See
AutoTrac Operator’s Manual for Shift Track
procedures.)
Press letter button next to RTK OPERATING MODE and
toggle to QUICK SURVEY BASE MODE.
30-4
121907
PN=92