Filter
Top Products
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsPlayback
Tuning in Radio Stations – XM Satellite Radio
To preset other channels, repeat steps 1 to 4.
NOTE
Preset channels are erased by overwriting them.
Presetting Radio Channels (Preset Memory)
Your favorite broadcast channels can be preset so that you can tune
them in easily. Up to 56 stations can be preset.
“LOADING” is displayed while channels or data are being received.
Refer to “Troubleshooting“ – “XM Satellite Radio“ (vpage 133)
regarding other messages.
•
•
Accessing XM Radio Channels Directly
1
Press o p.
2
Use o p to select the category, to use ui to select
the desired channel.
Channel category
1
Press [SEARCH].
2
Press [0 ~ 9] to input the channel.
Example: Accessing channel “XM123”: Press [1], [2] and [3].
If no button is pressed within several seconds, the channel
automatically switches to the one whose number has been input.
b
3
Press ENTER to set that channel.
Reception switches to the selected channel.
You can also operate via the main unit. In this case, perform the
following operations.
Press <TUNING PRESET>, then turn <SOURCE SELECT> to select the
preset radio channel.
1
Press [A ~ G] to select the memory block.
2
Press [CHANNEL] or [1 ~ 8] to select the desired
preset channel.
1
Tune in the broadcast channel you want to preset.
2
Press [MEMO].
3
Press [A ~ G] to select the block in which the channel
is to be preset, then press [CHANNEL] or [1 ~ 8] to
select the preset number.
The memory block can also be selected by pressing [SHIFT] on
the sub remote control unit.
b
4
Press [MEMO] again to complete the setting.
Listening to Preset Channels
Searching Categories
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
<SOURCE SELECT>
<STATUS>
<TUNING PRESET>
ENTER
uiop
[SEARCH]
ENTER
[CHANNEL]
[A ~ G]
[0 ~ 9]
[MEMO]
[ SAT TU]
uiop
[CHANNEL]
[A ~ G]
[MEMO]
[TUd]
[TU f]
uiop
[SOURCE
SELECT]
[1 ~ 8]
[SAT TU]
[ SAT TU]
[SHIFT]
[SAT TU]
Sub remote control unit
(MAIN mode)
(MAIN mode)