Filter
Top Products
0
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsMulti-zone
The operating procedure is the same for “q Zone Playback by Speaker Output” and “w Zone Playback
by Audio Output (PRE OUT)”.
Playback
1
Turn on the AVR-4810CI’s power.
(vpage 28 “Turning the Power On“)
2
Turn on the zone power.
Operation on the main unit
Press <ZONE2 ON/OFF>, <ZONE3 ON/
OFF> or <ZONE4 ON/OFF> for the zone to
be operated.
When the power turns on, the “ ”, “ ”
or “ ” indicator lights on the display.
Operation on the remote control unit
Press [MAIN] to display the mode for
the zone to be operated, the press [ZONE
ON].
When the power turns on, the “ ”, “ ”
or “ ” indicator lights on the display.
Also press [INPUT SOURCE SELECT] when in
standby mode, the power turns on.
When using ZONE2, ZONE3 or ZONE4, it is
possible to turn the power for the MAIN ZONE
only on or off by pressing [MAIN ZONE ON] or
[MAIN ZONE OFF].
b
b
3
Select the input source.
Operation on the main unit
q Press <ZONE2/3/4 / REC SELECT> and
select the zone to be adjusted.
w Turn <SOURCE SELECT> to choose the
input source.
Operation on the remote control unit
In the zone mode you want to operate,
press [INPUT SOURCE SELECT].
The same input source as in the main zone can
be selected easily by pressing the [M.ZONE
CALL] on the sub remote control unit.
b
<MASTER VOLUME>
<ZONE2/3/4 / REC SELECT>
<SOURCE SELECT>
<ZONE2 ON/OFF> <ZONE3 ON/OFF>
<ZONE4 ON/OFF>
uiop
[SLEEP]
[MENU]
[VOLUME]
[MAIN ZONE ON]
[MAIN ZONE OFF]
[MUTE]
[INPUT SOURCE
SELECT]
[ MAIN]
[ZONE ON]
[QUICK SELECT]
uiop
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
[QUICK
SELECT]
[SLEEP]
[ZONE ON]
[ MAIN]
Sub remote control unit
[M. ZONE CALL]
4
Adjust the item below.
Adjust the Volume
Operation on the main unit
q Press <ZONE2/3/4 / REC SELECT>
and select the zone to be adjusted.
w Turn <MASTER VOLUME> to
adjust.
Operation on the remote control unit
In the zone mode whose volume you
want to adjust, press [VOLUME].
GAdjustable rangeH
– – –
–80dB ~ –40dB ~ 18dB
(When the “Volume Display” setting is
“Relative”)
GAdjustable rangeH
0 ~ 41 ~ 99
(When the “Volume Display” setting is
“Absolute”)
Upon purchase, “Volume Limit” is set to “-
10dB (71)”.
Turning off the Sound Temporarily
(MUTE)
In the zone mode for which you want
to mute the sound, press [MUTE].
The sound is reduced to the level set at menu
“Mute Level” (vpage 53).
To cancel, either adjust the volume or press
[MUTE] again.
The setting is canceled when the zone’s power
is turned off.
The volume can be adjusted in ZONE2 and
ZONE3.
n
b
n
b
b
b
[ZONE ON]
[ MAIN]