Filter
Top Products
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsSettings
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
Error Messages
Main remote control unit
operation buttons
:Displaying the menu
Cancel the menu
:Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting :Return to previous menu
When Performing Audyssey Auto Setup Over
Again
Press ui to select “Retry”, and then press ENTER.
When Measuring has Stopped
Press RETURN, the “Cancel auto setup?” prompt is displayed.
Press o p and select “Yes”, then press ENTER.
n
n
An error message is displayed if it was not possible to complete
Audyssey Auto Setup due to speaker placement, the measurement
environment, etc. If this happens, check the relevant items, be sure
to take the necessary measures, then perform Audyssey Auto Setup
over again.
NOTE
Be sure to turn off the power before checking speaker connections.
Error messages (examples) Error contents
Measures
Correct measurement is not possible due to
inappropriate subwoofer volume.
• When using a subwoofer with built-in amplifier
(active type), use “SW Level Matching” to adjust
the subwoofer volume (vpage 38).
When using a subwoofer without a built-in
amplifier, select “Skip”, and then press ENTER.
•
•
Included setup microphone is not connected.
Not all speakers could be detected.
The front L speaker was not properly detected.
•
•
•
Connect the included setup microphone to the
SETUP MIC jack of the AVR-4810CI.
Check the speaker connections.
•
•
Too much noise in the room for accurate
measurements to be made.
Speaker or subwoofer sound is too low for
accurate measurements to be made.
•
•
Either turn off any device generating noise or
move it away.
Perform again when the surroundings are
quieter.
Check the speaker installation and the direction in
which the speakers are facing.
Adjust the subwoofer’s volume.
•
•
•
•
Displayed speaker could not be detected.• Check the connections of the displayed speaker.•
Displayed speaker connected with the polarities
reversed.
• Check the polarities of the displayed speaker.
For some speakers, this error message may
be displayed even if the speaker is properly
connected. If you are sure the connection is
correct, press ui to select “Skip”, then press
ENTER.
•
•