Filter
Top Products
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsConnections
Speaker Connections
B
: ZONE2 and ZONE3 speaker terminals
Use when installing multi-zone speakers or dedicated 2-channel
speakers.
q Connecting speakers for multi-zone (ZONE2/ZONE3)
Speaker connections
w qw q
(R) (L)
w qw q
(R) (L)
ZONE3
speakers
ZONE2
speakers
Relationship between “Amp Assign” settings and channels
output by each speaker terminal
“Amp Assign”
setting
(vpage 39 ~ 41)
Channels output by each speaker
terminal
Assign Mode ZONE2 ZONE3
+Z2 ZONE2 –
+Z2+Z3 ZONE2 ZONE3
n
n
w When front speakers for dedicated 2-channel DIRECT/STEREO
mode playback are bi-wired or bi-amped
Speaker connections
You can make Bi-amp or Bi-wire connections to one speaker system
which supports Bi-amp or Bi-wire connection as shown below.
Bi-amp or Bi-wire can only be used with speakers that support Bi-
amp or Bi-wire. Refer to your speaker manual.
(L) (R)
HIGH
LOW
w q
w q
HIGH
LOW
w q
w q
Front speaker (For Bi-Amp)
for 2CH DIRECT/STEREO
Relationship between “Amp Assign” settings and
channels output by each speaker terminal
“Amp Assign”
setting
(vpage 39 ~ 41)
Channels output by each speaker
terminal
“Front” ZONE2 ZONE3
2CH BW
b
FRONT (2ch BW) FRONT (2ch BW)
2CH BA
b
FRONT (2ch BA) FRONT (2ch BA)
b Can be selected when “Assign Mode” is “NORMAL”.
n
•
•
n
C
: Bi-Wir. or Bi-Amp speaker terminals
Use when front speakers are bi-wired or bi-amped.
Speaker connections
You can make Bi-amp or Bi-wire connections to one speaker system
which supports Bi-amp or Bi-wire connection as shown below.
Bi-amp or Bi-wire can only be used with speakers that support Bi-
amp or Bi-wire. Refer to your speaker manual.
Front speaker (For Bi-Amp)
(L) (R)
HIGH
LOW
w q
w q
HIGH
LOW
w q
w q
Relationship between “Amp Assign” settings and channels
output by each speaker terminal
“Amp Assign”
setting
(vpage 39 ~ 41)
Channels output by each speaker
terminal
“Front”
Bi-Wir. or
Bi-Amp
FRONT
Bi-Wiring
b
1 FRONT (BW) FRONT (BW)
Bi-Amp
b
2 FRONT (BA) FRONT (BA)
b1 Can be selected when “Assign Mode” is “NORMAL”, “+Z2” or
“+Z2+Z3”.
b2 Can be selected when “Assign Mode” is “NORMAL”.
n
•
•
n
These connections make for higher quality playback sound with no
interference between the signals of the bass and treble units.
When making a bi-amp connection, the same signal is output from the
front speaker terminal and the “Bi-Wir. or Bi-Amp“ terminal.
NOTE
Use speakers compatible with bi-amp connections.
When making bi-amp connections, be sure to remove the short-
circuiting plate or wire between the speaker’s woofer and tweeter
terminals.
•
•
About Bi-amp Connections