Filter
Top Products
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsSettings
Making Detailed Settings (Manual Setup)
Main remote control unit
operation buttons
:Displaying the menu
Cancel the menu
:Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting :Return to previous menu
Setting items Setting contents
2ch Direct/Stereo
(Continued)
Crossover : Outputs at below set frequency, each speaker’s bass signal
output from the subwoofer.
40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz
This can be set when “2ch Direct/Stereo” – “Subwoofer” is set to
“Yes”.
If the “2ch Direct/Stereo” – “Front” setting is “Large” and the “SW
Mode” setting is “LFE”, “Full Band” is displayed and the setting cannot
be made.
•
•
•
Distance FL / Distance FR : Select the speaker.
0.0ft ~ 60.0ft (12.0ft) / 0.00m ~ 18.00m (3.60m) : Set the distance to
the speaker.
Set so that the difference between the front left speaker and front
right speaker distances is 20.0 ft (6.0 m) or less.
•
Level FL / Level FR : Select the speaker.
–12.0dB ~ +12.0dB (0.0dB) : Adjust the level of each channel.•
Auto Surround Mode
Make setting for memorizing
surround mode setting for
each input signal type.
ON : Memorize settings. Automatically play with the last used surround
mode.
OFF : Do not memorize settings. Surround mode does not change
according to input signal.
The auto surround mode function lets you store in the memory the
surround mode last used for playing the four types of input signals listed
below.
q Analog and PCM 2-channel signals
w Dolby Digital and DTS 2-channel signals
e Dolby Digital and DTS multi-channel signals
r Multi-channel signals other than Dolby Digital and DTS (PCM, DSD,
etc.)
When playing in the PURE DIRECT, the surround mode does not change
even if the input signal is changed.
•
•
Setting items Setting contents
EQ Customize
Set so that unused equalizer
settings are not displayed
when MULTEQ XT on the
main remote control unit is
pressed.
Equalizer settings for which
“Not Used” is set with the
Quick Select function cannot
be stored and called out.
Audyssey Byp. L/R : Set when not using “Audyssey Byp L/R” equalizer.
Used : Use.
Not Used : Do not use.
Set so that “Audyssey Byp. L/R” settings can be made when Audyssey
Auto Setup is performed.
•
•
Audyssey Flat : Set when not using “Audyssey Flat” equalizer.
Used : Use.
Not Used : Do not use.
Set so that “Audyssey Flat” settings can be made when Audyssey
Auto Setup is performed.
•
•
Manual : Set when not using the “Manual” equalizer.
Used : Use.
Not Used : Do not use.
•
•