A SERVICE OF

logo

F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 6 - 9
Applications
Finishing
a) Cut the web of mount adhesive at the upper
unwind shaft with an enclosed blade.
CAUTION
Do not use an open blade to cut
the web near the rollers.
You can put cuts into the rollers!
b) Pull the precoated board and trailer board out
from the laminator.
This will prevent any exposed adhesive from
contacting the rollers.
INFORMATION
c) Raise the main rollers to a 1 in. gap by pressing
GAP
ss
ss
s.
GAP
PRESSURE
1
d) Remove the roll of material from the upper
unwind shaft.
e) Press STOP.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
f) Clean the rollers as described in the maintenance
section. ( Section 8.2 Cleaning the rollers )
g) Lower the front and rear safety shields and
press SHUTDOWN if finished with the
laminator.
SEL
SAV
SHUT DOWN
0
JOB
End of application