F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999Page 5 - 16
Operations
c) If heat is required, press TOP TEMP. s and
BOT. TEMP. s to desired settings. If no heat
is required, leave the settings at 68
o
F ( 20
o
C ).
TOP TEMP.
BOT. TEMP
SLEEP
68
68
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
d) Enter in the GAP setting desired by pressing
GAP t.
GAP
PRESSURE
1/4
INFORMATION
When storing parameters within the JOB
SAVE feature of the laminator, PRESSURE
is not a storable setting.
e) Enter a desired speed by pressing SPEED s.
FWR
REV.
STOP
GO
SPEED
SAFETY
3.5
f) Press SAVE to store the parameters in the job
location selected.
SEL
SAV
SHUT DOWN
1
h) Repeat steps “b” through “f” to save other
parameters in job location numbers.
CAUTION
If you accidentally press SAVE at any time,
the old parameters will be replaced with the
new parameters.
INFORMATION
You should store each job location with its
parameters on the chart provided in
Figure 5.4.1
