F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 6 - 41
Applications
r) Tape the web to the lower rewind tube or let the
web run out to a work table. Refer to Figure
6.5.6
If you choose to use the lower rewind tube,
make note of the direction of travel.
INFORMATION
Figure 6.5.6 Finish product rewind
Finished
product
rewind
Cut the piece
of cardboard
off
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
You may be CRUSHED or BURNED!
- Press on the variable speed footswitch to
lengthen the web enough to get one full wrap
around the lower rewind tube.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
s) Replace the front infeed table. Ensure that the
table is seated properly.
t) Close the front and rear safety shields.
INFORMATION
The SAFETY indicator should not be
flashing when the tables are properly
seated and the safety shields are in
the closed position..
u) Press STOP.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
