F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 5 - 5
Operations
( 21 ) SPEED s: When pressed, increases the speed
of the laminator in increments of 0.5 ft/min. When
pressed and held, speed will automatically increase by
0.5 ft/min increments until it has reached the maximum
allowed speed of 15 ft/min.
21
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
( 22 ) SPEED t: When pressed, decreases the speed
of the laminator in increments of 0.5 ft/min. When
pressed and held, speed will automatically decrease by
0.5 ft/min increments until it has reached 0 ft/min.
22
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
( 23 ) GO: When pressed, starts the rollers in motion.
GO is solid. This solid indication is referred to as the
“panel mode”. If a safety shield is raised during “panel
mode”, GO and SAFETY ( refer to ( 27 ) SAFETY
for explanation ) begin flashing enabling “footswitch”
mode. ( refer to ( 28 ) FOOTSWITCH for
explanation )
23
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
( 24 ) STOP : When pressed, stops the rollers and GO
becomes white.
24
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
( 25 ) FORWARD s : When pressed, signals the
laminator to run in a forward motion and FORWARD
s becomes solid.
25
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
( 26 ) REVERSE t : When pressed, signals the
laminator to run in a reverse motion and REVERSE t
becomes solid.
26
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
