F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999Page 8 - 2
Maintenance
8.2 Cleaning the rollers
Tools required
• Adhesive coated boards
( picks up dust and particles off of the rolls )
• Protective rubber gloves
( This will protect your hands from the isopropyl
alcohol )
• 80% isopropyl alcohol
( a mild dishwashing detergent and water may
be used instead )
• Rubber cement eraser
( a belt sander dressing block may be used
instead )
• Several 100% cotton terry cloths
( best for lint free cleaning )
Preparation of the laminator
a) Turn the MAIN POWER to the “ON”
position.
Power
b) Press RESET. The front control panel will
illuminated.
Reset
c) Press SEL.
SEL
SAV
SHUT DOWN
0
JOB
=
Flashin
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
WARNING
d) Open the front and rear safety shields.
e) Remove the front and rear tables.
