© GBC Pro - Tech August 1999Page 6 - 84
F - 160 Operation and Maintenance Manual
Applications
INFORMATION
Steps "n " and " o" will be performed
simultaneously.
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
You may be CRUSHED or BURNED!
k) Press down on the variable speed footswitch
just enough to give yourself a comfortable work
speed.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
WARNING
When the laminator rollers are in
motion, keep hands and fingers
away from the nip of the rollers.
You may be CRUSHED or BURNED!
l) Use one hand to pull the release liner off as the
substrate moves towards the nip and the other
hand to apply slight back tension to the decal.
m) Once the substrate and the decal are
completely through the pull rollers, you can let
off the variable speed footswitch.
n) The mounted image can now be removed from
the front of the laminator.
o) Trim the mounted piece as necessary.
Finishing
a) Press STOP.
FWR
REV.
STOP
GO
SPEED
SAFETY
9.0
