© GBC Pro - Tech August 1999Page 6 - 90
F - 160 Operation and Maintenance Manual
Applications
Figure 6.9.3 Laminate
Thermal
laminate
Remove
d) Apply just enough brake tension to prevent the
roll of thermal laminate from free spinning.
Excessive brake tension may cause the
output to curl. This can create complications
with the second pass of this application.
INFORMATION
e) Pull the thermal laminate from the bottom
unwind shaft up towards the upper main
roller and tack it the laminate resting on the
upper main roller. Refer to Figure 6.9.4
The mount adhesive will adhere to the
activated adhesive from the laminate.
INFORMATION
Figure 6.9.4 Lower laminate
Thermal
laminate
Thermal
laminate
f) Use a piece of cardboard to push the material
into the nip of the main rollers.
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
You may be CRUSHED or BURNED!
g) Press on the variable speed footswitch to guide
the cardboard and thermal laminate through the
main rollers.
