F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 8 - 1
Maintenance
Section 8 Maintenance
GBC Pro-Tech laminators require minimal
maintenance. However, regular maintenance is
essential to keep any piece of precision machinery
at peak performance. A maintenance schedule and a
section of procedures are included in this section.
WARNING
Do not wear ties, loose fitting clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
Improper maintenance, can result in
poor output quality.
INFORMATION
8.1 Maintenance Schedule
Below is a recommended maintenance
schedule. Before performing any of the steps
listed, read through the procedures first.
Please follow the instructions pertaining to
the step you are performing.
INFORMATION
Daily
• Clean the rolls
( See cleaning in this section )
• Inspect the electrical cord for damage.
( If damaged, you should replace or repair it
immediately )
• Inspect the footswitch cord for damage.
( If damaged, you should replace or repair it
immediately )
Monthly
• Adjust the nip if needed.
( See calibrations in this section )
• Check the chain tension.
( See calibrations in this section )
• Inspect the area around the laminator for
possible hazards
( dust buildup, combustible items
stored too close, etc. )
Semi-Annual
• Lubricate the grease fittings, chain, and gears.
( See Lubrication in this section )
• Check wire termination tightness.
ELECTRICAL
SHOCK
Remove power from the laminator before
servicing. You can be severely shocked,
electrocuted or cause a fire.
