F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999Page 5 - 4
Operations
( 15 ) JOB s : When pressed once will increase the
job number in JOB DISPLAY by increments of 1. If
pressed and held, the JOB DISPLAY will increase to
9 at which point it will stop.
SEL
SAV
SHUT DOWN
5
15
JOB
( 16 ) JOB t : When pressed once will decrease the
job number in JOB DISPLAY by increments of 1. If
pressed and held, the JOB DISPLAY will decrease to
0 at which point it will stop.
SEL
SAV
SHUT DOWN
5
16
JOB
( 17 )SEL : When pressed will send the operating
parameters for the stored job number selected to the
correct devices. Any time JOB s or JOB t is
pressed, SEL will flash indicating a change in job
number.
SEL
SAV
SHUT DOWN
5
17
JOB
( 18 ) SAVE : When pressed, will save the current
settings for the number showing in the JOB DISPLAY.
For more information, refer to Section 5.4 Job
Programming on how to save parameters.
SEL
SAV
SHUT DOWN
5
18
JOB
( 19 ) SHUTDOWN : When pressed, automatically
raises the main roller gap setting to 1 in., turns the top
and bottom temperature controller units off and stops
the drive motor. The LCD on the control panel remains
illuminated and the SLEEP indicator will be solid.
SEL
SAV
SHUT DOWN
5
19
JOB
( 20 ) SPEED DISPLAY : Displays the current speed
setting of the laminator.
20
FWR
REV.
STOP
GO
SPEED
SAFETY
6.5
