F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999Page 4 - 10
Installation
e) Ensure that nothing is in the path of the main roll
nip.
f) Confirm that power is supplied to the laminator.
g) Turn the MAIN POWER to “ON” position.
Main Power
h) Press RESET. The front control panel should
be illuminated at this point.
Reset
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
WARNING
i) Raise the front safety shield. The SAFETY
indicator will begin flashing.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
= Flashing
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
j) Press GAP t to “0”.
GAP PRESSURE
0
