F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 4 - 21
Installation
r) The TOP TEMP DISPLAY and BOT TEMP
DISPLAY are solid indicating the actual
temperature is within a +/- 10
o
F of the set point
temperature.
TOP TEMP.
BOT. TEMP
SLEEP
120
120
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
WARNING
s) Raise the front safety shield, remove the front
infeed table and touch the two main rollers.
They should feel warm to the touch.
t) Replace the front infeed table and lower the
front safety shield.
INFORMATION
The SAFETY indicator should not be
flashing when the tables are properly
seated and the safety shields are in
the closed position..
u) Press SHUTDOWN. The laminator reverts to
the default settings and SLEEP is solid. Refer
to Figure 4.8.1
SEL
SAV
SHUT DOWN
0
JOB
Figure 4.8.1 Default settings
FWD
REV
STOP
GO
GAP
PRESSURE
SPEED
TOP TEMP
BOT TEMP
SEL
SAV
SAFETY
SLEEP
SHUT DOWN
68
68
1
00.0
0
= Flashing
