F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 6 - 89
Applications
s) Press SPEED
ss
ss
s to set a motor speed of
2 ft. / min. ( .6 m / min. )
FWR
REV.
STOP
GO
SPEED
SAFETY
2.0
t) Press GAP
tt
tt
t to enter a 0 in. gap setting.
GAP PRESSURE
0
u) Press GO.
FWR
REV.
STOP
GO
SPEED
SAFETY
2.0
v) Continue with step “w” when the TOP TEMP
DISPLAY and BOT TEMP DISPLAY stops
flashing.
w) Press STOP.
FWR
REV.
STOP
GO
SPEED
SAFETY
2.0
Process
a) Raise the front safety shield and remove the
front infeed table.
b) Apply just enough brake tension to prevent the
roll of thermal laminate from free spinning.
Excessive brake tension may cause the
output to curl. This can create complications
with the second pass of this application.
INFORMATION
c) Pull the thermal laminate straight down toward
the front infeed table so that approximately 6 in.
is resting on the front infeed table. Refer to
Figure 6.9.3
