© GBC Pro - Tech August 1999Page 6 - 50
F - 160 Operation and Maintenance Manual
Applications
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
WARNING
When the laminator rollers are in
motion, keep hands and fingers
away from the nip of the rollers.
You may be CRUSHED or BURNED!
o) Use one hand to pull the release liner off as the
substrate moves towards the nip and the other
hand to apply slight back tension to the decal.
p) Once the substrate and the decal are completely
through the main rolls, you can let off the
variable speed footswitch.
q) The mounted image can now be removed from
the rear of the laminator.
r) Trim the mounted piece as necessary.
Finishing
a) Press STOP.
FWR
REV.
STOP
GO
SPEED
SAFETY
9.0
b) Press GAP
ss
ss
s to a 1 in. setting.
GAP
PRESSURE
1
c) Clean the rollers as described in the
maintenance section. ( Section 8.2 Cleaning
the rollers )
d) Lower the front and rear safety shields and
press SHUTDOWN if finished with the
laminator.
SEL
SAV
SHUT DOWN
0
JOB
End of application
