F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 6 - 93
Applications
o) Press SPEED
ss
ss
s to a speed you feel
comfortable working with. It is recommended
that SPEED not exceed 5 ft./ min.
( 1.52 m/ min. ) .
FWR
REV.
STOP
GO
SPEED
SAFETY
9.0
p) Press GO.
FWR
REV
.
STOP
GO
SPEED
SAFETY
9.0
q) Feed the images through the main rollers from
the front operating position of the laminator.
r) After the last print has passed through the pull
rollers, press STOP.
FWR
REV.
STOP
GO
SPEED
SAFETY
9.0
s) Press GAP
ss
ss
s to a 1 in. setting.
GAP
PRESSURE
1
Finishing
a) With an enclosed blade, cut the finished product
from the web.
CAUTION
Do not use an open blade to cut
the web near the rollers.
You can put cuts into the rollers!
b) The prints are now ready to be trimmed.
c) If you used the lower rewind, remove the
rewind tube and bring it to a trimming station.
Replace the rewind tube when finished.
d) Raise the front and rear safety shields to the up
position.
