F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 5 - 3
Operations
( 11 ) PRESSURE DISPLAY : Displays the amount
of pressure being used. Each bar represents 10% of the
maximum allowable pressure. All ten bars illuminated
equals 100% of the maximum allowable pressure.
GAP PRESSURE
1/4
11
INFORMATION
When adjusting the pressure, the gap
will be affected as well.
( 12 ) PRESSURE s : When pressed once, will
decrease the pressure by 5%. If held down, it will
decrease from 100% of the maximum allowed pressure
to 0% at which point no bars will be illuminated.
GAP
PRESSURE
1/4
12
WARNING
Keep hands and fingers clear of
the laminator roller nip when
adjusting PRESSURE.
You can be CRUSHED or BURNED!
( 13 ) PRESSURE t : When pressed once, will
increase the pressure by 5%. If held down, it will
increase from 0% of the minimum allowed pressure to
100% at which point all bars will be illuminated.
GAP PRESSURE
1/4
13
( 14 ) JOB DISPLAY : Displays the job number
selected and will set the operating parameters saved for
that number once SEL has been pressed.
SEL
SAV
SHUT DOWN
5
14
JOB
INFORMATION
Job programming is explained in
Section 5.4
