Safety F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999Page 1 - 14
PRESSURE will vary with the thickness
and width of the laminate you are using.
Adjust as necessary.
INFORMATION
The leading edge is the first part of the
board or image that enters the nip
of the rollers.
INFORMATION
Position the leader board squarely
onto the mount adhesive.
INFORMATION
CAUTION
Prolonged contact can form flat spots on the
rollers.
CAUTION
When manually setting the main roll nip,
observe the substrate to prevent crushing.
INFORMATION
When requiring top and bottom heat, it is
recommended to set both temperatures to
the same set point.
If the main laminating rollers are heated,
mounting application may be run from the
rear operating position of the machine.
INFORMATION
INFORMATION
Do not add PRESSURE when heating the
laminating rollers, this allows the high
release silicone to expand with minimum
restrictions.
Slow speed will assists with heat up times
and distributes heat evenly.
INFORMATION
