© GBC Pro - Tech August 1999Page 6 - 14
F - 160 Operation and Maintenance Manual
Applications
d) From the center, use one finger to tack down
the leading edge of the image to the leading
edge of the precoated board. Refer to Figure
6.2.6
The leading edge is the first part of the
board or image that enters the nip
of the rollers.
INFORMATION
Figure 6.2.6 Tack leading edge
Avoid tacking at the ends first and pressing
towards the center, you may create a tunnel
once you have reached the center. This will
make for a difficult mounting application.
INFORMATION
e) Set the precoated board with the image tacked
to it in the center of the front infeed table.
f) Press STOP.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
g) Press FWD
ss
ss
s.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
h) Push the leading edge of the precoated board
up to the nip of the main rolls.
WARNING
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
You may be CRUSHED or BURNED!
i) Using the variable speed footswitch, slowly
work the precoated board into the nip of the
rollers. Stop just before the end of the tacked
down section of the image enters the nip.
