F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 6 - 5
Applications
Excessive pressure will cause the
substrate to bow or flatten.
INFORMATION
q) Press STOP.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
r) Press REV
tt
tt
t to reverse the direction of the
motor.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
WARNING
When operating the laminator through the
variable speed footswitch, keep your hands
away from the nip of the rollers. You may
be crushed or burned.
s) Press on the variable speed footswitch to back
the board out of the main rollers.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
Process
a) Pull the roll of mount adhesive straight down
toward the front infeed table so that
approximately 6 in. is resting on the front infeed
table. Refer to Figure 6.1.3
Figure 6.1.3 Leader board
Leader
board
Mount
adhesive
b) Position the leader board so that half is adhered
to the mount adhesive. Refer to Figure 6.1.3
Position the leader board squarely
onto the mount adhesive.
INFORMATION
