© GBC Pro - Tech August 1999Page 6 - 72
F - 160 Operation and Maintenance Manual
Applications
Ensure the roll of mount adhesive is
loaded properly on the unwind shaft.
Exposed adhesive should be
facing away from the rollers.
This will prevent hours of roll cleaning!
CAUTION
l) Push the clevis pin back down to secure the
unwind shaft in its saddle.
m) Center the upper roll and the lower roll of
material on the unwind shafts. You may refer to
your measurement chart in Section 5.3.2
Loading film ( Figure 5.3.4 )
INFORMATION
For the lower unwind shaft, add 1/4 in. to
the measurement.
n) Lower the safety shields.
If you have the parameters stored as a
JOB number enter it now then press
SEL and skip to step " p ", other wise
continue with step " l".
INFORMATION
o) Press SEL. SEL will stop flashing.
SEL
SAV
SHUT DOWN
0
JOB
p) Press TOP TEMP
ss
ss
s to set a temperature of
220-230
o
F ( 104-110
o
C ).
TOP TEMP BOT TEMP
SLEEP
68140
q) Press FWD
ss
ss
s
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
