F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 5 - 15
Operations
f) Press SEL to engage the parameters.
SEL
SAV
SHUT DOWN
0
JOB
g) Press GO to engage the motor drive system.
FWR
REV.
STOP
GO
SPEED
SAFETY
2.0
h) When the rollers are close to it’s set point value,
the temperature displays stop flashing,
pressSTOP and raise the gap to 1 in. by
pressing GAP s
GAP
PRESSURE
1
5.4 Job programming
The job save feature is very convenient if the
same parameters are required to perform various
applications. This procedure will guide you step by step
through this feature.
a) Follow the prcedure in Section 5.3.1 Power.
INFORMATION
When the laminator is first turned on, the
front control panel will go into the default
mode.
Default mode; TOP TEMP. = 68
o
F ( 20
o
C ),
BOT. TEMP. = 68 oF ( 20 oC ), GAP = 1 in.,
PRESSURE = no bars are solid, JOB = 0, no
motion direction selected, SPEED = 00.0 and
SLEEP = flashing
b) Press JOB s to enter the desired job number
for the parameters you require to be stored.
SEL
SAV
SHUT DOWN
1
JOB
