Filter
Top Products
You can set the transmission data rate for LDAC playback.
1. Select [Setup] - [Bluetooth Settings] from the home menu.
2. Select [Wireless Playback Quality].
3. Select the setting you want.
Auto: Sets the transmission data rate for LDAC automatically.
Sound Quality: The highest data rate is used. Sound is sent at a higher quality, but
audio playback may become unstable if the link quality is not sufficient.
Standard: A medium data rate is used. This provides a balance between sound
quality and playback stability.
Connection: Stability is prioritized. The sound quality may be reasonable and the
connection status will most likely be stable. This setting is recommended if the
connection is unstable.
Note
This function is only available when [Bluetooth Mode] is set to [Transmitter] and
[Bluetooth Codec - LDAC] is set to [On].
[199] Adjusting Settings
Zone Settings (for STR-DN1060 only)
Turning the power for Zone 2/Zone 3/HDMI zone on/off
(Power) (for STR-DN1060 only)
You can turn the power for Zone 2/Zone 3/HDMI zone on or off by following the steps below.
1. Select [Setup] - [Zone Settings] from the home menu.
2. Select [Zone2 Power], [Zone3 Power] or [HDMI Zone Power].
3. Select [On] or [Off].
Note
The amplifiers in the zones other than the main zone remain turned on even when the
receiver is in standby mode (press (on/standby) on the remote control to turn off the
receiver).
When the receiver is in standby mode, the on/standby indicator on the front panel lights