Filter
Top Products
1. Select [Transmitter] in [Bluetooth Mode] from the Bluetooth Settings menu.
[BT TX] appears on the display panel.
2. Turn on the BLUETOOTH function on the BLUETOOTH headphones.
3. Select the name of the BLUETOOTH headphones from the [Device List] in the
Bluetooth Settings menu.
If you cannot find the name of your BLUETOOTH headphones in the list, select [Scan].
4. Start playback of the audio source via the receiver.
The sound is output from the BLUETOOTH headphones.
5. Adjust the volume.
Adjust the volume level of the BLUETOOTH headphones first. If the volume level is still
too low, adjust the volume level on the receiver. The volume level of the receiver cannot
be controlled when BLUETOOTH headphones are connected. +/– on the remote
control and MASTER VOLUME on the receiver only work for the BLUETOOTH
headphones.
Note
You can register up to 9 sets of BLUETOOTH headphones. If a 10th set of BLUETOOTH
headphones is registered, the least recently connected BLUETOOTH headphones will be
replaced by the new ones.
The receiver can display up to 15 detected BLUETOOTH headphones in the [Device List].
You cannot change the sound effects or settings in the options menu while transmitting
sound.
Some content cannot be output due to copyright protection.
The audio output from the BLUETOOTH headphones may be delayed compared to that
from the receiver because of the characteristics of BLUETOOTH wireless technology.
No sound is output from the speakers or HDMI OUT jacks when BLUETOOTH
headphones are successfully connected to the receiver.
The [Screen mirroring], [Bluetooth] and Home Theatre Control functions are disabled
when the receiver is in transmitter mode.
The receiver does not support BLUETOOTH headphones with the NFC function.
Hint
You can enable or disable the reception of AAC or LDAC audio from the BLUETOOTH
device.
You can also switch the [Bluetooth Mode] using BLUETOOTH RX/TX on the remote
control.
If the BLUETOOTH device in step 2 is the most recently connected device, you can
connect it to the receiver automatically by simply pressing BLUETOOTH RX/TX on the
remote control. In this case, you do not need to perform step 3.