Filter
Top Products
available only when the monitor supports the A/V Sync function.
0 ms – 300 ms: You can adjust the delay from 0 ms to 300 ms in 10 ms intervals.
Note
The receiver may play signals at a lower sampling frequency than the actual sampling
frequency of the input signals, depending on the audio format.
This function is not available when [Bluetooth Mode] is set to [Transmitter].
[162] Adjusting Settings
Audio Settings
Time-aligning the LFE (low frequency effect) channel
(LFE Time Alignment)
The LFE Time Alignment function allows you to shift the output timing of the LFE channel
forward for other channels. This function is effective for adjusting content in which there is a
gap between the LFE channel phase and other channel phases.
1. Select [Setup] - [Audio Settings] from the home menu.
2. Select [LFE Time Alignment].
3. Select the setting you want.
0 ms – 20 ms: You can adjust the gap from 0 ms to 20 ms in 0.5 ms intervals.
Note
This function does not work in the following cases:
[Pure Direct] is set to [On].
[2ch Stereo] or [Analog Direct] is being used.
Headphones are connected.
A speaker pattern without the subwoofer is selected.
The front speaker size is set to [Small].
No LFE signal is input.
[Bluetooth Mode] is set to [Transmitter].
[163] Adjusting Settings Audio Settings
Adjusting the volume automatically (Advanced Auto