Filter
Top Products
9
PREPARATION
En
This manual is for the VSA-E08 Audio/Video Multi-
Channel Amplifier.
This manual is divided into three main sections which
will tell you how to setup and use the unit :
PREPARATION
First carry out the tasks below in this “Before You
Start“ section to prepare the remote control, then
connect the amplifier to your other components as
described in “Connecting Your Equipment“ (p.12-20).
Take special care to connect your digital equipment
like DVDs and LDs properly to be able to take
advantage of the amplifier’s surround sound systems.
To learn about a specific button, control, or indicator,
see “Displays & Controls“ starting on p.21.
SET UP
Performing the tasks in “Initial Set Up“ (from p.27) is
essential to get proper surround sound.
OPERATION
To play some music or soundtrack refer to “Basic
Playback“ on p.41. Doing the operations in “Remote
Control of Other Components“ (p.52) is highly
recommended so you can use this unit’s remote
control for all your components. “Using Other
Functions“ (p.66) explain the other possibilities of the
amplifier.
“Techno Tidbits & Problem-solving“ (p.73) provide
detailed technical information and a troubleshooting
guide.
The following marks and symbols are used throughout
the manual:
Provides additional information,
precautions, and advice.
Indicates a blinking button, indicator, or
display.
Indicates a steadily lit button, indicator, or
display.
Before You Start
Checking the Supplied Accessories
Please check that you have received all of the following supplied accessories.
How to Use This Manual
Preparing the Remote Control
Loading the batteries
Load the batteries into the remote control as shown below. The remote control uses a lot of power due to the
LCD display so please use alkaline batteries. Depending on individual use you may have to change the batteries
fairly often but most users should be able to get an average of 1-3 months of battery life. When you notice a
decrease in the operating range or if the alarm sounds (see next page), replace all batteries with new ones.
NOTE: After replacing the batteries, the touch panel will need re-adjusting (see p.28-29).
ª
ª
ª
ª
·
·
·
·
12 3
\
\
“AA” IEC LR6
batteries x 4
Remote control unit
Touch pen
Cushion for
Remote x 4
(Attached to the back
of the remote control)
CAUTION!
Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions.
• Never use new and old batteries together.
• Insert the plus and minus sides of the batteries properly according to the marks in the battery case.
• Batteries with the same shape may have different voltages. Do not use different batteries together.
• When disposing of used batteries, please comply with governmental regulations or environmental public institution’s
rules that apply in your country or area.
“AA” IEC LR6
batteries x 4
memo
Operating Instructions