Filter
Top Products
10
En
Touch pen
Change Battery !!
OK ?
SIZE AA, LR6SIZE AA, LR6
lock switch
Remote Control Battery Alarm
When the batteries get too weak to operate the remote control properly an alarm
will sound and a warning screen will appear on the remote. Change the batteries as
shown on the previous page.
The Touch Pen & Lock
The touch pen is located in the back right-hand corner of the
remote control. Take it out by sliding your finger along the bottom
right edge of the remote control and then grasping the pen with
thumb and forefinger.
The lock switch is located in the top right-hand corner on the back
of the remote control. When this switch is set to LOCK you can’t
use the buttons on the remote control. This is helpful to prevent
you from mistakenly pushing a button. For normal use keep the
switch set in USE.
Remote Control Cushions
Apply the cushions to the feet of the remote control as shown in the
diagram right.
Operating range of remote control unit
The area in which you can use the remote control to operate the
VSA-E08 is fairly large. To use, point the remote control toward
the remote sensor on the front panel of this unit while within
the range shown right.
Remote control may not function properly if:
• There are obstacles between the remote control and the
remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The amplifier located near a device emitting infrared rays.
• Operated simultaneously with another remote control which
uses infrared rays.
30
30
7m
Before You Start