Filter
Top Products
50
En
Basic Playback
MULTI CHANNEL IN Playback
MULTI CH IN allows you to connect an external decoder to enjoy certain types of specialized discs. To use
MULTI CH playback follow the instructions below.
memo
MULTI CH IN
Amplifier
MAIN SUB
DSP STEREO
THX
ADVANCED
THEATER
EFFECT
STANDARD
MIDNIGHT
LOUDNESS
MULTI CH
IN
SIGNAL
SELECT
DIGITAL
NR
/ dts / MPEG
MULTI CH IN
MULTI CHANNEL IN Setting
There are two types of MULTI CH IN settings: ADJUST and BYPASS. In the former you can change the sound
level and in the latter it's fixed. To move between the two settings follow the procedure below:
Press the MULTI CH IN button on
the remote control’s Amplifier MAIN
screen or the MULTI CH INPUT
button on the front panel.
Each press switches the input between the previous
mode and MULTI CH IN.
When MULTI CH IN is selected only the volume
level can be set. All of this unit’s other features
(DIGITAL NR etc.) cannot be used. Also, In BY-
PASS mode all speaker settings and other setup
settings have no effect.
1
Put amplifier in STANDBY.
2
While holding down the MULTI CH INPUT
button press the STANDBY/ON button.
The setting will change depending on what state the receiver was
previously in. For a few seconds the display will show you which
MULTI CH setting you are now in.
ADJUST: Use the ADJUST setting when you want to be able
to control each channel level individually.
BYPASS:
This setting is good for getting the cleanest possible signal.
In this setting you won’t be able to change each channel individually.
We recommend using BYPASS and the default setting is BYPASS.
MULTI CH INPUT
STANDBY/ON
dB
STEREO
SIGNAL
SELECT
SP
A
DIGITAL
AUTO
VOLUME
memo
96 kHz 24 bit Performance
This amplifier is capable of playing back advanced DVD discs which are recorded in 96 kHz/24 bit format (these
are all stereo discs) and any source recorded in 96 kHz and up to 24 bit. The amplifier will automatically read the
format of the disc and play accordingly (of course the SIGNAL SELECT will have to set to AUTO or DIGITAL to
read the DVD soundtrack). When the amplifier plays a 96 kHz/24 bit disc "96 kHz" and whatever mode you're
using (for example "STEREO," "DIRECT or " DNR") will appear in the display.
• When a 96 kHz/24 bit disc is played back the volume
may be louder than that of a normal disc.
• Some DVD players cannot play 96 kHz/24 bit discs.
Check the manual of your DVD player to make sure.
• During this playback the player enters the STEREO
mode and you can use the controls available in
STEREO mode (LOUDNESS, MIDNIGHT, TONE
controls, etc., see p.48-49).
• With 96 kHz/24 bit discs you are able to use MULTI
CH IN playback and the TAPE 2 MONITOR.
• In 96 kHz/24 mode you can't use the STANDARD,
ADVANCED THEATER, THX, or DSP modes.
MAIN
dB
SIGNAL
SELECT
ANALOG
SP
A
VOLUME