Filter
Top Products
OPERATION
OPERATION
63
En
Remote Control of Other Components
Tuner
1
2
4
7
8
9
5
6
3
DIRECT
ACCESS
DISP
MODE
RF
ATT
+
+
–
–
CLASS
BANDMPX
STATION
TUNING
0 L1
1
2
4
5
6
3
7
-890
memo
1
Press to switch the TUNER on or off (not possible
with all models, especially those without a
standby mode).
2 BAND
Switches between AM and FM radio bands.
3 MPX
Press to switch between auto stereo and mono
reception of FM broadcasts. When the broadcast
signal is weak, selecting mono will improve the
sound quality.
4 TUNING –/+
Use to manually tune to radio stations.
5 STATION –/+
Use to choose programmed radio stations.
6 Number buttons
Use to input stations and frequency.
7 L1
Use to program selections (not possible with all
models).
8 DIRECT ACCESS
Allows you to input a frequency directly.
9 CLASS
Use to select the class (A, B or C) that a preset
station is in.
0 DISP MODE
Use this to switch between display modes.
- RF ATT
Press to turn the RF attenuator on when
receiving strong FM signals (nearby stations) to
reduce sound distortion.
Tuner operations
• The following operations are available from the amplifier's remote control after you program
your FM/AM tuner into it, but some operations may need to be learned separately by the
amplifier (see “Setting Up the Remote Control to Control Other Components,“ p.52-55).
• To perform these operations, press the LINE/TUNER button to set the remote to the CD operation
mode.
• For more information on individual commands consult the manual that came with the component.